THIS IS A SOURCES SOUGHT NOTICE. NO SOLICITATION IS AVAILABLE AT THIS TIME.Any information submitted by respondents to this Source Sought Notice is voluntary. The Air Force does not intend to award a contract on the basis of this notice or to otherwise pay for the information solicited. Respondents should not construe this notice as a commitment by the Air Force for any purpose and should refrain from providing proprietary information in the response.INTRODUCTION: The contractor shall provide all required products.The contractor shall provide the following:Laser EtcherThe laser etcher should meet the below specifications:Laser etcher/cutter for CTK tool etching/engraving, awards, and toolbox foam organizer creation, signs. Has a minimum 36“ x 48“ enclosed working area / maximum 110 volts/50–60hz/single phase power / minimum 120W+ C02 laser
↧